Removal and fitting of engine bushes

This guide will show you how to remove the old engine bushes using our extraction tool and then to fit your new ones.

The red one has already been done. Now to remove the white one at the bottom.

First place the spacer tube on the inner side, with the cap washer on top. Place the long bolt through and a nut on either end.

Hold one nut and turn the other until the bush comes out.

Insert the new bush by placing it on the inner side, with the cap on the other side as shown in the picture.

Continue to turn the nut until the bush is nearly in then use the spacer tube to pull it all the way in.

To purchase bushes direct from our shop please click here