To Replace rear suspension bushes

1. Put the bike on the centre stand

2. Open the seat and remove the small square cover in the back left corner

3. Undo the nut (which holds the top end of the shocker in)

4. Undo the bolt at the bottom of the shocker located by the engine cover

5. Pull the bottom end of the shocker backwards to remove it

6. Replace the rubber bush at the top end of the shocker with the larger of the two new bushes

7. Push the shocker back into place and do up the bottom bolt

8. Place the smaller bush on top, inside the seat and then do up the nut

To purchase these direct from our shop please click here